Thingiverse
Narwhal
0
Downloads
3
Likes
0
Makes
This is a friendly version of a Narwhal, a 1.75 mm slice of raw filament acts as its tusk.
This model cannot be sized because resizing it will affect the hole that the filament is inserted into.
No supports needed, you can also try experimenting with variable layer height features in your slicer to smooth the back out.
Please always monitor children playing with 3D prints, this model is recommended for older children and it is also recommended to round off the end of the raw filament/tusk area for safety.
Filaments used in photo- Panchroma Starlight Mercury PLA and Polylight PLA in Black and Panchroma Silk PLA in Silver Silk for the tusk
This model cannot be sized because resizing it will affect the hole that the filament is inserted into.
No supports needed, you can also try experimenting with variable layer height features in your slicer to smooth the back out.
Please always monitor children playing with 3D prints, this model is recommended for older children and it is also recommended to round off the end of the raw filament/tusk area for safety.
Filaments used in photo- Panchroma Starlight Mercury PLA and Polylight PLA in Black and Panchroma Silk PLA in Silver Silk for the tusk
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
