NASA Logo

I remixed this to be printed on a single extruder printer.

The way I do it will only work on a printer with a BL-Touch type probe that will hit the direct center of the bed. Each color is a completely new print. DON'T LET THE BED COOL DOWN BETWEEN PRINTS or the tips of the red will start to curl up. Don't peel off the purge line either. Once the entire logo is printed in blue (one piece logo), send the next color as a new print and the probe will hit the blue and think that is the Z-zero of the bed and print the new print on top of the blue full logo. It just so happens that the probe will only hit the blue unless your build plate is a different size and Cura centers it different than on an Ender 3.

I print this right side up versus the original being upside down.

I tried doing all three colors, upside down, on one layer but it doesn't come out very well due to typical first layer type issues that would normally fix themselves in taller prints, but because this print is on