Native Instruments Maschine Angle Stand

My first design and I've decided to share it.

Just a very simple stand that I made for my NI Maschine MK1. I wanted it at a more comfortable angle and didn't want to have any screws or glue applied to my device. I came up with the idea of using the stock screw holes on the base of the device and designed pins to fit snugly in them. Works a treat!

Not tested with MK2, Studio or MK3 Maschine. The MK2 looks similar but the MK3 will definitely not work.

You could print of 2 of these and put one on each end of the device but I find just the one in the middle is sturdy enough for me.

Installation: Simple as taking it off your print bed, turning your maschine over and inserting the 2 pins in the top screw holes. They fit pretty snug but you shouldn't have to force them. If they are too tight to easily get them in, you may want to sand them down a little. You don't want to be forcing them in so hard that you bend your device!

The pictures attached are of the first versio