NCase M1 Custom Computer Case Feet

8/31/17
- Requested to add a version of the feet without the ridges

Always hated how the NCase M1 feet were so low profile. Made these to make the computer case higher for better airflow as well as vibration dampening using AcoustiFeet Rubber inserts.

The plastic printed feet is 15mm high and with the rubber insert its about another 2mm. So about 17mm high when its all said and done.

Printed these in PLA 0.2mm - 100% Infill
Rubber Inserts: https://www.amazon.com/AcoustiFeet-ACF3007-20B-Anti-vibration-Soft-30lbs/dp/B003VREHJ4

- Not sure if you can put other rubber inserts in them, but the inner diameter for the inserts are 30mm and the other diameter is 40mm. Uses the same screw that attaches the old feet.