Ncase M2 Vertical Stand

Ncase M2 Vertical Stand, Uses the 4 thumb screws on the back of the case to use as the base. Remove the rear 2 feet and replace with the longer tapered screws provided by ncase to align with the two holes on the 3d printed base. Adds enough height not to bend factory power cable and display cord very much.Final edition is cut to accept the bottom power location and back plate is centered between power and motherboard ports. NO SUPPORTS Photos printed in PETGDetails:.16 high quality20% infill Gyroid2 WallsInside/OutsideFuzzy Skin 0.1/0.1 Contour