Thingiverse
Neato180 Backmount Antenna Array
von rollinsio
4
Downloads
4
Likes
0
Makes
This is a full antenna back mount for the Neato 180.
It holds frsky or long antennas at a 45 degree angle to the frame and each other as well as offering a pass-through for the VTx antenna.
Best printed in TPU, this will leave a tad bit of squeeze space for the power harness to pass through.
It holds frsky or long antennas at a 45 degree angle to the frame and each other as well as offering a pass-through for the VTx antenna.
Best printed in TPU, this will leave a tad bit of squeeze space for the power harness to pass through.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
