Thingiverse
Nebula camera mount
door PunaPrints
0
Downloads
0
Likes
0
Makes
This extension will allow to mount the Creality Nebula camera Infront of the hot plate for a cinematic and front view.
There are options for M3 heat insert nuts or pass through holes that will allow to use M3 HEX nuts. There are also 2 versions for the wire clips on both side (depends on where your printer's controller is). Also have a version where there are no clips for the wire.
The clearance Is there for bot the frame and the belt pully. HEX pattern for less material and air circulation as its close to the hot bed. Its very sturdy and no shakes on the time-lapse.
Attached are pictures and a GIF for the perspective of the camera.
Printed with PLA-silk, 0.08mm layer hight, 30%infill. M3 screws and HEX or inserts nuts.
Let me know if anything.
Enjoy
There are options for M3 heat insert nuts or pass through holes that will allow to use M3 HEX nuts. There are also 2 versions for the wire clips on both side (depends on where your printer's controller is). Also have a version where there are no clips for the wire.
The clearance Is there for bot the frame and the belt pully. HEX pattern for less material and air circulation as its close to the hot bed. Its very sturdy and no shakes on the time-lapse.
Attached are pictures and a GIF for the perspective of the camera.
Printed with PLA-silk, 0.08mm layer hight, 30%infill. M3 screws and HEX or inserts nuts.
Let me know if anything.
Enjoy
PunaPrints publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
