Thingiverse
Nebula Capsule 2 Stand
door gbevin
34
Downloads
43
Likes
1
Makes
This is a ceiling projection stand for the Nebula Capsule 2 projector.
To assemble, just slide the panels together, the pictures should provide good examples.
Note that the longest vertical panel with the circular cut out has an orientation to it, the cutout is angled downwards. The lowest point should be towards the inside of the assembled stand.
These were the considerations when designing it:
* Provide very stable support for the projector
* Quick and easy to use
* Works on the floor, night stand, bed, book shelf, ...
* Adjustable angles
* Works with a small USB key plugged in
* Works with USB-C power cable plugged in
* Packs flat and fits in the Nebula Capsule 2 carrying case
* Easy to print without supports
To assemble, just slide the panels together, the pictures should provide good examples.
Note that the longest vertical panel with the circular cut out has an orientation to it, the cutout is angled downwards. The lowest point should be towards the inside of the assembled stand.
These were the considerations when designing it:
* Provide very stable support for the projector
* Quick and easy to use
* Works on the floor, night stand, bed, book shelf, ...
* Adjustable angles
* Works with a small USB key plugged in
* Works with USB-C power cable plugged in
* Packs flat and fits in the Nebula Capsule 2 carrying case
* Easy to print without supports
gbevin publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
