Nebula Capsule 3 - Wall/Ceiling mount

Modified to work with the capsule 3, this mount is specifically for ceiling attachment though it is snug enough that it should work fine on a wall without slipping.

**NOTE: THIS IS NOT THE LASER VERSION**

Uses the same sliding mount for easy removal.
Arms have 4mm holes ready for M3 5.7x4.6mm heat press inserts.
Retention arms use a 12mm M3 bolt to screw together holding the capsule snug.

Designed to avoid covering any of the intake/exhaust vents at the top and bottom along with leaving enough space from the ceiling to allow standard USB C and right angle HDMI cables to be connected.
The arms should fit between the camera and lens and leave the IR receiver at the back uncovered. Top should be placed just below the power button and the lower will fit just above the camera.

If needed, you may need to cut the retention model vertically down the middle to print them individually.