Thingiverse
NEC MultiSync 3D Control Door
von Started1213
1
Downloads
4
Likes
0
Makes
Update- released a new version made from the ground up, over at Printables
Replacement control door for the vintage NEC MultiSync 3D CRT Monitor. Does not use the original latching mechanism, just friction. Clips right on just like a lego figures hands.
The hinges are press-fit into the slots on the door, very solid with Cura set to .05mm hole expansion. A dab of superglue couldn't hurt, though. I did not make them integrated into the door due to layer lines & supports that would make them very weak, also not smooth.
The two hinges are different lengths, so make sure to print one of each.
Creative Commons, Non-Commercial.
Replacement control door for the vintage NEC MultiSync 3D CRT Monitor. Does not use the original latching mechanism, just friction. Clips right on just like a lego figures hands.
The hinges are press-fit into the slots on the door, very solid with Cura set to .05mm hole expansion. A dab of superglue couldn't hurt, though. I did not make them integrated into the door due to layer lines & supports that would make them very weak, also not smooth.
The two hinges are different lengths, so make sure to print one of each.
Creative Commons, Non-Commercial.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!