Thingiverse
Necklace Display Bust
door Sheridan156
179
Downloads
159
Likes
2
Makes
This is my first attempt at a necklace display for a store or market front.
Prints best as shown in the last picture (angle of 150 degrees). You will need to scale this part down to 45% to fit comfortably inside a 200mm*200mm*200mm printer.
I then used Double sided tape to cover the print in material for a professional looking finish that i am quite pleased with!
Any questions? just ask
Chris
Prints best as shown in the last picture (angle of 150 degrees). You will need to scale this part down to 45% to fit comfortably inside a 200mm*200mm*200mm printer.
I then used Double sided tape to cover the print in material for a professional looking finish that i am quite pleased with!
Any questions? just ask
Chris
Sheridan156 publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
