Thingiverse
Necklace holder
par JariStyrman
105
Téléchargements
127
Likes
1
Makes
This is a necklace holder where you can rest your jewelry. Total height is about 30 cm and it's in 3 pieces. I did three print's until I was happy.
Tolerances aren't always easy but I'm more of a "the tighter fit the better"- kind of guy. I ended up printing this in low quality (0,3 mm layer height) and had to spend a minute or two sanding to get a nice snug fit. Printing in higher resolution should provide a perfect fit.
Other than designing necklace holders I occasionally read a book, there is one book that is about me, you can find it here: https://www.amazon.com/dp/B079BT3RG6
Happy printing!
Tolerances aren't always easy but I'm more of a "the tighter fit the better"- kind of guy. I ended up printing this in low quality (0,3 mm layer height) and had to spend a minute or two sanding to get a nice snug fit. Printing in higher resolution should provide a perfect fit.
Other than designing necklace holders I occasionally read a book, there is one book that is about me, you can find it here: https://www.amazon.com/dp/B079BT3RG6
Happy printing!
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !