Thingiverse
Learning
Zum Modell
Needle Disposal System
34
Downloads
27
Likes
0
Makes
WARNING: THIS 3D PRINTED NEEDLE DISPOSAL SYSTEM SHOULD ONLY BE USED BY HEALTHCARE INSTITUTIONS AFTER CAREFUL EVALUATION AND TESTING. USERS ASSUME ALL RESPONSIBILITY FOR THE SYSTEM'S USE.
**DESCRIPTION**
This is a needle disposal system designed to fit repurposed HDPE plastic containers with 35mm outside diameter, 5mm spaced threading. The design requires a tether which can be custom-made or use a simple twist tie.
50+ of these systems are currently in use at a local children's hospital after several months of evaluation, testing, and design iterations.
Some of the images are of older versions with a single notch for detaching needles from syringes. The STL file features two notches.
**USE**
The inner cap fits onto the bottle's threading. It has two notches on either side to catch and assist in removing a needle from a syringe. Once the needle is inside the bottle, the outer cap is fitted on top using two more securing notches to keep the bottle closed until its nex
**DESCRIPTION**
This is a needle disposal system designed to fit repurposed HDPE plastic containers with 35mm outside diameter, 5mm spaced threading. The design requires a tether which can be custom-made or use a simple twist tie.
50+ of these systems are currently in use at a local children's hospital after several months of evaluation, testing, and design iterations.
Some of the images are of older versions with a single notch for detaching needles from syringes. The STL file features two notches.
**USE**
The inner cap fits onto the bottle's threading. It has two notches on either side to catch and assist in removing a needle from a syringe. Once the needle is inside the bottle, the outer cap is fitted on top using two more securing notches to keep the bottle closed until its nex
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
