Slicer Discord
Needle Point Meter Probe Case – Modelo 3D imprimible de Thingiverse Thingiverse

Needle Point Meter Probe Case

62 Descargas
40 Likes
1 Makes
Ver Modelo
These are case for the snap on needle points for meter test leads.
There are two sets of files one is for Fluke needle points and one for Keysight/Aligent/HP needle points.
I printed with PLA yellow. The yellow is semi-transparent so you can see if the points are in the case.
You may need to adjust the X Y scaling in the slicer if the inside bore is too tight.
You should only scale it by 0.1 at a time.
Also keep in mind you need to scale the cap at the same time.
The caps just snap on using the layer lines to hold them.
I have had good luck with this.
Print this slow I print at 30mm/s.

Layers = 0.2mm
No Support required
Print positions see photos
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección