Thingiverse
NEET patch
door ErKoRo
1
Downloads
3
Likes
0
Makes
My first independent model. I was looking for a PATCH NEET to install on a helmet or equipment, but there were no analogues.
It is enough to paint and glue the velcro on the back side. Choose the size when printing based on your needs. The thickness of the model allows you to bend under the profile of the helmet, if necessary, you can briefly heat with a lighter and give the necessary bend.
Thank you if you read to this point :)
It is enough to paint and glue the velcro on the back side. Choose the size when printing based on your needs. The thickness of the model allows you to bend under the profile of the helmet, if necessary, you can briefly heat with a lighter and give the necessary bend.
Thank you if you read to this point :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!