Thingiverse
Nekoosa Rocket
por nekoosa_peters
0
Descargas
2
Likes
0
Makes
A lightweight payload delivery system for Alexander Middle School's Tech Ed program.
This design opts out of recovery wadding and, instead, uses a sabot to eject the payload.
Payload size is limited to 2 inches in diameter and just over 3 inches in length. The payload bay was sized this way so a parachute and an egg could easily fit.
The rocket, nose cone and sabot pieces tumble to the ground after payload delivery. This payload delivery system is designed for a single use only; it is not reusable. The engine retainer part is intended to be hot-glued in place, to secure the engine in place.
57 grams printed weight. Printed on X1C, with standard settings, no brim.
Uses 18mm engine sizes; successfully tested with B6-2.
Capable of lifting an egg or similar mass.
This design opts out of recovery wadding and, instead, uses a sabot to eject the payload.
Payload size is limited to 2 inches in diameter and just over 3 inches in length. The payload bay was sized this way so a parachute and an egg could easily fit.
The rocket, nose cone and sabot pieces tumble to the ground after payload delivery. This payload delivery system is designed for a single use only; it is not reusable. The engine retainer part is intended to be hot-glued in place, to secure the engine in place.
57 grams printed weight. Printed on X1C, with standard settings, no brim.
Uses 18mm engine sizes; successfully tested with B6-2.
Capable of lifting an egg or similar mass.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!