Thingiverse
Nema 17 back cover
von tmorris9
54
Downloads
40
Likes
0
Makes
I was going to use this to make some wire management changes to my printer but decided to go a different route. You can use this for any purpose.
It's a snug fit (won't fall off even during fast printing) that goes on the back of a standard NEMA 17 stepper motor. It has a hole in the end mostly for weight concerns but also allows some heat from the motor dissipate better than if it were closed up.
If you find a use I would love to see what it is.
It's a snug fit (won't fall off even during fast printing) that goes on the back of a standard NEMA 17 stepper motor. It has a hole in the end mostly for weight concerns but also allows some heat from the motor dissipate better than if it were closed up.
If you find a use I would love to see what it is.
tmorris9 veröffentlicht auch auf
89 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
