Thingiverse
Nema 17 Pancake Bracket
door dintid
7
Downloads
2
Likes
0
Makes
A simple bracket to hold my Nema 17 Pancake motor, which I use for my Belted Extruder V2. for 1.75mm Bowden.
If you use a full sized normal Nema 17, you might want to take a look at my Nema 17 motor mount bracket
It might seem fragile, but the rounded edges makes for a really strong piece of a small bracket :)
BOM:
5x m3 nuts
1x m3 20mm screw to lock the Nema 17 in place.
4x m3 screws with a length to mount to your printer etc.
If your m3 nuts are loose, I suggest you use a drop of glue on them, to avoid them falling out when trying to attach the bracket.
If you use a full sized normal Nema 17, you might want to take a look at my Nema 17 motor mount bracket
It might seem fragile, but the rounded edges makes for a really strong piece of a small bracket :)
BOM:
5x m3 nuts
1x m3 20mm screw to lock the Nema 17 in place.
4x m3 screws with a length to mount to your printer etc.
If your m3 nuts are loose, I suggest you use a drop of glue on them, to avoid them falling out when trying to attach the bracket.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
