Thingiverse
NENG 618C Multimeter Stand
von RobinAbbott
4
Downloads
1
Likes
0
Makes
The N618C is a great little, cheap and cheerful multimeter. However it has the leads out the bottom and is not great to use flat so this is a print for a stand.
No supports required, print on the side. Didn't need raft or brim but some printers might.
Owing to Centre of Gravity it needed to be a bit bigger than normal.
No supports required, print on the side. Didn't need raft or brim but some printers might.
Owing to Centre of Gravity it needed to be a bit bigger than normal.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!