Neptune 4 Max Printable Front Panel

After moving over to OpenNept4une on my Neptune 4 Max, I decided I wanted to have easier access to the micro-SD slot on the front of my mainboard, but also didn't want to have to cut into or damage the original front panel just in case I ever decide to sell it or revert it back to stock. So... I modeled and designed a printable front panel for it that includes a micro-SD slot. (I also did this so that I could put a small lip under the micro-SD opening so that there wasn't a gap for the card to end up falling inside the unit if you weren't super careful....).

I designed it to be in two pieces for easier printing and added a little emblem plate in the front to cover where the two pieces join together (and made a couple of plates to go with it... blank, OpenNept4une logo, Elegoo, etc). As the slope on my front is slightly different to allow for easier modification, I also modeled and included a new drawer that matches up with the look. The original drawer will also still fit but it jus