Thingiverse
Nerdy Tea Infuser
von catarina
67
Downloads
122
Likes
2
Makes
Voltage regulated tea :)
I couldn't get the typical tea infuser holes to print nicely (too small), so I used a different approach: a large hole on the back covered by a grid that lets the water in and out while keeping the tea leaves inside.
I couldn't get the typical tea infuser holes to print nicely (too small), so I used a different approach: a large hole on the back covered by a grid that lets the water in and out while keeping the tea leaves inside.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
