Thingiverse
Nerf Caliburn - Grip Insert
door captainslug
618
Downloads
366
Likes
7
Makes
UPDATE: The older Grip assembly (3 part) uses Grip2insert. The newer one uses Gip5insert.
Nest a 10-32 hex nut into the slot in the bottom then screw slide the 8-inch threaded rod through FrontButt, the 6-inch spacer, then screw it into the nested hex nut until there's JUST ENOUGH threaded rod remaining to get another hex nut onto the exposed end of it.
Nest a 10-32 hex nut into the slot in the bottom then screw slide the 8-inch threaded rod through FrontButt, the 6-inch spacer, then screw it into the nested hex nut until there's JUST ENOUGH threaded rod remaining to get another hex nut onto the exposed end of it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
