Thingiverse
Nerf Centurion Gear
von Crazymotoman03
21
Downloads
18
Likes
0
Makes
The priming gear on my centurion broke, so I designed a new one that seems to be working pretty good.
It may just be my printer, but there is a little hump that forms inside the hex hole that makes it difficult to slide the hex shaft in. so heat it up gently with a lighter and tap it in, or find a way to remove the lip if needed.
It may just be my printer, but there is a little hump that forms inside the hex hole that makes it difficult to slide the hex shaft in. so heat it up gently with a lighter and tap it in, or find a way to remove the lip if needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!