Nerf Dart Compatible Drain Blaster

An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.

Instructions:

Printing:

1st Side:
Print on the side that connects to the drain blaster
Use supports
50% infill
4 perimeters

2nd Side:
Print on the side that connects to the drain blaster
Use supports
50% infill
4 perimeters

Single Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters

Triple Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters

Ten Shot Capsule:
Print on the side that connects to the adapter
Use supports
5% infill
4 perimeters

Assembly:

Materials you will need:
6 m3 screws 25mm or cut to fit
6 m3 nuts
12 3mm washer
1 15mm×2,5mm o-ring
2 60mm×2,5mm o-rings(per capsule)

Main Blaster:

Put the drain blaster between the 1st and 2nd side.
Put a washer on each screw and screw them in.
Before you put the nut on, place another washer