Nerf hanging / swinging target

Needed a target to hang in the airsoft tent for indoor nerf testing. Wanted reactive - so it was fairly clear which ring was hit. And not to use pounds of filament 3mm thick but shelled to 1.5mm, 6mm thick up at the pivot .

250mm diameter, just fits on a P1S, I printed the red / white on separate plates.

Needs a M3x40 ish bolt, 6 M3 washers (think I used 1/8" honestly - just to keep the swing arms from rubbing) Nut didn't quite fit in the 5mm hole, but a heatset insert did with a bit of superglue to secure. Yeah I could improve those eyelets, but close enough for this purpose.