Thingiverse
Nerf Hyper Rush-40 T-pull, Spring Spacer
por haphazardlynamed
31
Descargas
23
Likes
2
Makes
T-pull Priming Handle for the Nerf Hyper Rush-40.
As the Rush-40 needs to be held upright when priming in order to feed properly, racking the slide is problematic - I habitually rack pistol slides by holding them sideways. Adding a T-Pull allows an alternate hand position to avoid this issue.
No shell cutting, replaces the sliding dust cover on the rear underside of the slide.
Spring Spacer, adds more spring compression, install into the rear (fixed side) of the spring rest, not on the plunger end. Puts mine to about 120fps, up from ~107fps stock.
As the Rush-40 needs to be held upright when priming in order to feed properly, racking the slide is problematic - I habitually rack pistol slides by holding them sideways. Adding a T-Pull allows an alternate hand position to avoid this issue.
No shell cutting, replaces the sliding dust cover on the rear underside of the slide.
Spring Spacer, adds more spring compression, install into the rear (fixed side) of the spring rest, not on the plunger end. Puts mine to about 120fps, up from ~107fps stock.
haphazardlynamed también publica en
115 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
