Nerf Hyperfire 180 Motor Cover
von Grentarc
12
Downloads
9
Likes
0
Makes
I designed this cover to fit over my 180 motors on my Hyperfire - the photo is of the v6 revision, v7 has the bottom right corner following the angles of the hyperfire a little better.
To mount it, you just need to position the cover on the Hyperfire, mark out the 4 holes for the screws and pilot drill the holes with a 2mm drill bit, then use the standard Nerf shell screws to attach.
To mount it, you just need to position the cover on the Hyperfire, mark out the 4 holes for the screws and pilot drill the holes with a 2mm drill bit, then use the standard Nerf shell screws to attach.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
