Nerf Picatinny Riser - small

A picatinny riser that can go on worker rails.

If you like your optic or you flashlight a bit higher.

Works with worker rails, though depending on the quality of your print, you might need to sand the inside of the rail a little.

I don't know if it works on other 3d printed rails.

UPDATE 2018-08-30 : I revised the design a little after having trouble getting a good print. The rail was a bit too tight and the riser was not printing that well. This is an upgraded design that a friend is printing for me. If the result turn out good, I'll post a picture.