Slicer Discord
Nerf Pilot Safety Delete – 3D printable model from MakerWorld MakerWorld
Other Toys & Games

Nerf Pilot Safety Delete

6 Downloads
9 Likes
2 Makes
Go to Model
In my opinion, the safety on most (all?) Nerf Rival products is backwards. Your finger should push a safety away to disengage, and pull it towards you to engage. Nerf/Hasbro decided otherwise. After what was probably the 3rd time I attempted to draw my Nerf Pilot from my holster only to have the safety engaged by the friction of its removal and subsequently being left unable to fire my blaster at a critical moment, I decided it had to go. It would also be less than ideal to just chop it up or simply remove the plastic bit - leaving a gap. So I cobbled this thing together using primitives in Bambu Studio, and some slight changes in blender. I'm quite the novice at modeling, so it isn't perfect, but it's a lot better than just leaving an annoying and unsightly hole under the trigger guard. To use it simply open up your blaster (there are 2 screws that aren't like the others - pay attention) ,remove the pieces shown below the blaster in the photo (careful, there is a sprin
Category
Other Toys & Games
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection