Thingiverse
Nerf Rayven Handguard
door BaronWaste
4
Downloads
3
Likes
0
Makes
Designed this for the Nerf Rayven but should fit all variants.
Measurements were slightly out so had to use a hairdryer to slightly reshape at two bends to get just the fit I was aiming for.
Used a small hand drill to make holes in the centre of the bolt shapes and then added screws.
Left space at the head of the screw to fit within the body of the blaster and made some grooves in the blaster shell to accommodate the screws.
Measurements were slightly out so had to use a hairdryer to slightly reshape at two bends to get just the fit I was aiming for.
Used a small hand drill to make holes in the centre of the bolt shapes and then added screws.
Left space at the head of the screw to fit within the body of the blaster and made some grooves in the blaster shell to accommodate the screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!