Nerf Recon CS-6 kit

Hello o/

My first go at a redesigning the look of a Nerf blaster.
This one is for the Recon CS-6 and replaces some of the stock parts and adds a short barrel.

You'll need to dismantle your stock by removing the two pins at the connection end. You can tap these out a couple of mm with a small screwdriver or a nail and then pull the rest of the way with pliers. Keep the pins, they will be going back in.
Also unscrew and remove the center part of the stock. This part will not be going back in.

Printed parts in the images:
STOCK-1
STOCK-2

STOCK-2 can be printed with the rear side down onto the build plate. I printed with raft and supports. Any supports that generate around the rivets or elsewhere can be removed, the part only needs the support underneath.
25% infill, about 19.5 hours print time.
STOCK-1 can be printed front or back to the build plate. If you go front, remember to generate supports.
25% infill, 10 hours print time.

Push STOCK-2 over the rails on