Nerf Recon Stock

Hello

Additional stock part for Nerf Recon.

We printed the awesome stock parts by keidora2002, but my son wanted the back part of the stock (where the spare magazine goes) filled in too, so some fiddling around in Tinkercad and this part was born...

I made the bolt holes deeper so that it still takes 25mm M3 or M4 nuts and bolts. I used M3 with washers for the bolts.
Ideally the whole thing should be glued and bolted, but we didn't want to wreck the original stock. Everything stays in place well but of course you can twist the parts around if you fiddle with them.

Printed on a Voxelab Acquila and a Geetech A10T (1 half on each) with gold PLA (eSun).
Print time was about 2 hours per piece.
Printed at 50% infill, raft and supports. No finishing was done to the pieces in the photo. The raft and supports peeled away in one piece.

Thanks