Thingiverse
Nerf Retaliator Trigger Spacers
55
Downloads
33
Likes
1
Makes
Nerf Retaliator Trigger Spacers
These Spacers Shorten the trigger pull distance of the Retaliator.
Makes the Trigger Pull more responsive.
Attach using Epoxy.
Post Printing: there is a .5mm Support wall that should be Cut off before fitting to the trigger.
This support helps with print bridging.
-I am aware that bridging/support would be unnecessary if the part was printed upright; however by printing sideways, the layer lines present a Smoother surface to slide against the Catch.
These Spacers Shorten the trigger pull distance of the Retaliator.
Makes the Trigger Pull more responsive.
Attach using Epoxy.
Post Printing: there is a .5mm Support wall that should be Cut off before fitting to the trigger.
This support helps with print bridging.
-I am aware that bridging/support would be unnecessary if the part was printed upright; however by printing sideways, the layer lines present a Smoother surface to slide against the Catch.
haphazardlynamed also publishes on
115 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
