Thingiverse
Nerf Rival Apollo Pump Conversion and stock
832
Descargas
577
Likes
8
Makes
Hello everyone,
I decided to release my design to the world. Here is my take on the Nerf Apollo Pump conversion, after looking online at a few different 3d printed Nerf Apollo pump conversions, I decided to take tidbits of each that I liked and compile them into my own design. This whole design and build are a work in progress and I have not tested this set up in a Nerf War yet. I have printed out a previous iteration of the design, of which you can see the attached pictures of. The design hasn't changed too much since that iteration. Make sure to set up your slicer to print in the best way you know possible to reduce supports and bed adhesion. Experiment/print at your own risk!
I have also designed a stock attachment. Please excuse the tape on the stock, I printed them in two pieces then epoxied puttied together because I was testing fit.
I appreciate any feedback/comments!
Please feel free to tip me or donate to me for the work on this design if you are so inclined to do
I decided to release my design to the world. Here is my take on the Nerf Apollo Pump conversion, after looking online at a few different 3d printed Nerf Apollo pump conversions, I decided to take tidbits of each that I liked and compile them into my own design. This whole design and build are a work in progress and I have not tested this set up in a Nerf War yet. I have printed out a previous iteration of the design, of which you can see the attached pictures of. The design hasn't changed too much since that iteration. Make sure to set up your slicer to print in the best way you know possible to reduce supports and bed adhesion. Experiment/print at your own risk!
I have also designed a stock attachment. Please excuse the tape on the stock, I printed them in two pieces then epoxied puttied together because I was testing fit.
I appreciate any feedback/comments!
Please feel free to tip me or donate to me for the work on this design if you are so inclined to do
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!