Nerf Sprinter Half dart Kit

Self developed kit to adapt the new Nerf N-series Sprinter to a half dart capable blaster.

Two versions of the Mag adapter are included, one with a support piece in the mag release detent, one without, some tweaking may be required in the slicer to get a clean support for the overhang.
The Mag release should probably be printed with a higher infill to prevent flexing, I went with 50% and seems fine.
The only additional hardware needed is 1 m3 *18 screw for the mag release. You can reuse the spring from the original mag release by sliding it in the hole in the back of the magwell once the release is installed.
In the Stock magwell are 2 thin walls that protrude to release the dart holder tabs in the original mag, In the end I've elected to just trim these down to fit the magwell in.

The Magwell lock piece simply friction fits into the slot in the back of the magwell and into the existing mag release slot in the sprinter, while the Mag release filler closes up the old mag releas