Nerf technical(RC controlled)

Roughly a week of development for this one and probably around 6 less successful prints, this is what came of it!

You hook it up to a receiver and use it as a standalone turret och put it on a RC vehicle. I hotglued it to the flatbed of my 3D printed RC truck V3, quite fun!

As usual I went wild with hardware ... You need these:
2x M3 rods x 40mm
2x m3 rods x 75mm
6x M4x10
19x m3x10
10x m3x16
3x standard size servos
2x 6700zz bearings
Couple of rubberbands or springs

2016-11-02 edit: Added the missing pushpin.

You can find videos about this project and others at my youtube channel: https://www.youtube.com/mrcrankyfaceprojects

Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface
Patreon: http://patreon.com/Mrcrankyface