Nespresso vertuo capsule holder

A nespresso vertuo capsule holder.

This is only a prototype, so if you print it, take into account the following:

1. You need to adjust the height. This only fits three capsules.
2. There is no need for support or infill; everything is 45-angled. However, there's a tiny bridge of a straight line.
3. I printed using Cura's default "low quality" profile, which is a 0.28 nozzle profile, which seems ok.
4. For usability, it should either be mounted to a wall or hung in some way that is not embedded in the design yet.

If you like it, I'll be publishing version 2 sometime soon.