Nespresso Vertuo Pop+ Additional Height Base

NESPRESSO VERTUO POP+ ADDITIONAL HEIGHT BASE

My wife's tall coffee cups did not fit under her new coffee maker, so I 3D printed this base to raise it up 20mm.
This is my original design.

Check the dimensions shown in NespressoPop+BaseDimensions.png to ensure that your coffee maker matches this design.

The overall model is 200mm wide and 250mm deep.
The base adds 20mm of height for large coffee cups.
4 Pins protruding from the base fit into the deep holes on the coffee maker where it is screwed together to prevent the coffee maker sliding off the base.

SLICING:
There are no bridges and no supports are required.
I printed the overall model with 0.4mm nozzle and 0.42 line width and 0.2mm layer height.
6 bottom shell layers and 8 top shell layers.
Walls 4 lines thick.
10% rectilinear infill on the diagonal.
To ensure enough strength when closing the lid or snapping the water container in place, I modified sections of the model.
Under the pins and the feet, I used 40% infill.
Under the