Nest Hello Mounting Bracket Full Frame

* Full frame to allow for address or messages
* Extended "keyhole" (see note)
* Wider cutout to allow for USB power
* Angled version if needed (print with supports, face up, and parallel to print bed; see picture)
* Screw covers will protrude slightly; cut in slicer to flush-fit
* Use slicer to add address to top of frame (e.g., emboss, cut through, or layer)

Note: the extended "keyhole" allows a pin to continue pressing the (relatively stiff) doorbell mount spring until the doorbell is seated, alleviating the pressure on the locking tab. Without it, very tough filament (or metal) might be required to prevent the locking tab from breaking.