Slicer Discord
nestedGyroscopicPrecessionLeverage45° – 3D-Druckmodell von Thingiverse Thingiverse
Engineering

nestedGyroscopicPrecessionLeverage45°

1 Downloads
1 Likes
0 Makes
Zum Modell
Time travel.
I noticed a non-linerar timespace phonomana while forcing a gyroscope to process in the opposite direction of its natural course of entropy in a 45° tilt going the opposite direction of the turning wheel. That is why this is serious.

This is a partially finished rough draft of a device meant to take advantage of gyroscopic precession leverage as much as possible at 45° tilt nested multiple times. My plan is to make the gear to gear ratio dynamic and the direction of each nested section independently reversible. Alternatively the gears can be swapped out in an N/M=1 ratio where N is one gear M is the second gear. M could Also have 2 conjoined gears that spin in unison as to have 2 different diameters virtually but this would require another gear size H.
The joints need to be connected with ball bearings or some kind of spinning joint at each spinning junction with gears.
The sections are partitioned so one can pass electricity though each arm independently with conduc
Kategorie
Engineering
Quelle
Thingiverse
Veröffentlicht
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen