MakerOnline
Tools
Zum Modell
NetAlly LinkSprinter LS300 hard case
17
Downloads
6
Likes
0
Makes
A hard case for the NetAlly LinkSprinter LS300 Pocket Network Tester. I bought mine used so it didn't come with the soft protective cover. I hope to improve on the original soft cover by including a space to store the two AA batteries outside of the LinkSprinter which will eliminate the risk of them leaking inside and corroding the electronics. Assembled case dimensions: x: 58mm y: 160mm z: 38mm The photos show the actual printed parts in eSUN PLA+ (Peak Green): 0.4mm nozzle 0.2mm layer height 3 Perimeters 20% Inflill Supports: No. Parts required for assembly: Print 1x Base Print 1x Top Print 1x Clip 3x 5mm x 50mm bolts and nuts - 1x for the hinge and 2x for the clip. I recommend locking nuts or thread locking glue so they don't loosen when hinging the case open and closed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!