Thingiverse
netatmo outdoor Sensor holder
von kse
12
Downloads
5
Likes
0
Makes
Simple holder for a netatmo outdoor sensor.
You should not use it on ground level (no thief protection). The Outdoor module just slides into the holder.
I printed it in eSun ePA-CF Filament, but every uv and heat resistant filament should do. So: do not use PLA or PETG. ASA should be fine.
You should not use it on ground level (no thief protection). The Outdoor module just slides into the holder.
I printed it in eSun ePA-CF Filament, but every uv and heat resistant filament should do. So: do not use PLA or PETG. ASA should be fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
