Thingiverse
Netatmo sensor holder
von Laeman
9
Downloads
8
Likes
0
Makes
A support for the Netatmo door and window sensors. It makes easier to change the batteries and upgrade the firmware on the sensors, when you shall move them close to the camera.
On the rear part it has a flat surface to stick a 20 mm large double sided tape strip.
I provide the STEP file but if you use OnShape you can clone the original project (public) [here](https://cad.onshape.com/documents/f4f51d202428c98150ba3e87/w/73ad6a2816b7a3496ee71916/e/2a0bdf41571d0deb06b730ce).
On the rear part it has a flat surface to stick a 20 mm large double sided tape strip.
I provide the STEP file but if you use OnShape you can clone the original project (public) [here](https://cad.onshape.com/documents/f4f51d202428c98150ba3e87/w/73ad6a2816b7a3496ee71916/e/2a0bdf41571d0deb06b730ce).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!