Netatmo Sensor Mount (Wind & Rain) for 40x40 Pipe

Mount for Netatmo Wind and Rain Sensor for 40x40mm Square Tube Mount for Netatmo Wind & Rain Sensor for 40x40mm Square Tube   My Netatmo wind and rain sensors needed to be securely and neatly attached to a 40x40 mm stainless steel square tube – without a wobbly DIY solution, without a zip-tie artwork, and especially without a mount that slowly turns into sad plastic pudding in the sun 😅 So I designed this mount   The best part: It fits both the wind sensor and the rain sensor equally. If you want to mount both, simply print the part 2x – done The clamp fits snugly on the square tube, holds stably, and the screws/nuts disappear flush into the mount This means: everything remains nicely smooth on the outside, and nothing protrudes annoyingly Why this model was created aka: "PLA eventually becomes nonsense outdoors") The previous mount was a purchased PLA version – and it completely fell apart over time outdoors No kidding The material was so degraded that the sensors almost took an involuntary dive Since then, the issue is clear: For outdoor use, please do not cut corners   Recommendation for outdoor use: at least PETG better ABS or ASA with lots of sun, preferably directly UV-resistant filament In short: PLA indoors is great – outdoors in continuous sun is more of a brave experiment 🌞🔥   What the mount can do Suitable for Netatmo Wind Sensor & Netatmo Rain Sensor Designed for 40x40 mm square tube Clean clamp mounting Flush screwing (no protrusion) One model for both sensors (print 2x if needed) Assembly (without a nervous breakdown) The mount is screwed around the 40x40mm square tube with a two-part clamp I have integrated a small lock into the flange pieces so that the two parts do not constantly go on a world tour during assembly This makes the setup much more relaxed Small practical tip: It's best to press the nuts into the recesses with a short screw before final assembly Saves swearing, saves time, saves nerves 😄 In addition, screw heads and nuts sit flush in th