MakerWorld
Music
Model downloaden
NEW GUITAR WALL MOUNT
205
Downloads
59
Likes
48
Makes
Guitar or Bass Guitar Wall mount IDEALLY FOR SYMMETRIC GUITAR HEADS (Fender strats etc will fit but you may get a slight tilt due to the headstock geometry not being symmetrical)hidden Screw Design. Fix bracket to wall then slot mount over43mm and below necks - MUST print bracket laying down so layer grain runs the length or bracketMUST print the mount standing up. If not, I can not guarantee the strength of the part. 0.2 layer heightMinimum of 3 wall thickness30% triangular infillThe guitar mount works great in quality PLA, but stronger materials would be beneficial. See the image attached for hole dimensions. I used M4 Screw. Approx 40mm in lengthUse suitable wall fixings to avoid failure.
DT3D_PRINT publiceert ook op
90 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
