Thingiverse
Newmen Hub Cap Puller
von ricardoplumeros
4
Downloads
5
Likes
1
Makes
Tool designed to help remove the caps from Newmen Fade mountain bike hubs - may fit other Newmen hubs for this purpose but not tested on others.
Used together with a bar through the hub and mallet to remove the caps allowing the hub bearings to be inspected/cleaned/removed.
Newmen do produce a tool for this job however it is quite expensive.
Printed on Ultimaker 3 in PLA with 100% infill and no support.
Used together with a bar through the hub and mallet to remove the caps allowing the hub bearings to be inspected/cleaned/removed.
Newmen do produce a tool for this job however it is quite expensive.
Printed on Ultimaker 3 in PLA with 100% infill and no support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!