Thingiverse
NexStar 6SE Dewshield
por apexio
8
Descargas
3
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/9kaM0xHEqeC
ABS. 0.2mm layers, 30% infill. This is a tall and thin print. If the corners lift, try supergluing them down after the first 20 layers or so.
After printing, paint acetone over the entire outside. It makes a nice glossy finish and really increases the strength.
The dewshield has a flange that friction fits onto the 6SE. You can glue the extension onto this print to get a full 240mm dewshield.
ABS. 0.2mm layers, 30% infill. This is a tall and thin print. If the corners lift, try supergluing them down after the first 20 layers or so.
After printing, paint acetone over the entire outside. It makes a nice glossy finish and really increases the strength.
The dewshield has a flange that friction fits onto the 6SE. You can glue the extension onto this print to get a full 240mm dewshield.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!