Thingiverse
Nexus 5 Case
door EvilTeach
20
Downloads
16
Likes
0
Makes
I was enamored of BLeds Nexus 5 case, but wanted some changes.
Here is a derivative with the changes.
Currently I am using one printed in glow-in-the-dark abs.
08/23/2016 - The resulting print is too fragile for practical use.
I glued some cracks together and it works fine.
In fact with the slits, the model could be printed a little smaller.
08/24/2016 - Ninja flex printed ok. It fused tightly to the kapton tape on a few of the letters. Since it is so flexible it can be printed a little bit smaller.
Also the earphone jack needs widened for larger male jacks.
Here is a derivative with the changes.
Currently I am using one printed in glow-in-the-dark abs.
08/23/2016 - The resulting print is too fragile for practical use.
I glued some cracks together and it works fine.
In fact with the slits, the model could be printed a little smaller.
08/24/2016 - Ninja flex printed ok. It fused tightly to the kapton tape on a few of the letters. Since it is so flexible it can be printed a little bit smaller.
Also the earphone jack needs widened for larger male jacks.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
