Thingiverse
Nexus 5 Wireless Charging Stand
door kalzenith
1
Downloads
3
Likes
0
Makes
This stand is intended to hold an LG Nexus 5 in portrait mode. You can glue a wireless charger circuit board/coil in the rear cavity, then glue the back plate on. There is about 7mm or 8mm of clearance for the circuitry.
(Warning: I haven't had a chance to print this yet to see if it works.)
(Warning: I haven't had a chance to print this yet to see if it works.)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!