Thingiverse
Nexus 6 / Phablet Wall Mount
door Wedge5x5
5
Downloads
2
Likes
1
Makes
Wall mount holder for phablets, 83-87mm wide, upto 13mm thick.
I based the dimensions on my Nexus 6, factoring the curved back, in a slim gel case and it is a loose, but safe fit.
It has 3 countersunk holes for hard mounting and enough surface area for any other sticky-based mounting approach.
It is notched along the lower face to allow the Nexus 6 lower speaker to be unobstructed and there is a generous opening in the base to accommodate centred and slightly offset USB connections.
I might revise the design to cater for other phablet / large phone connection configurations and also allow better airflow to the rear-position microphone of the Nexus 6. Let me know if you want something specific, and I'll see what I can do.
If you are printing this for a Nexus 6, you could print this at 95% for a firmer fit.
I based the dimensions on my Nexus 6, factoring the curved back, in a slim gel case and it is a loose, but safe fit.
It has 3 countersunk holes for hard mounting and enough surface area for any other sticky-based mounting approach.
It is notched along the lower face to allow the Nexus 6 lower speaker to be unobstructed and there is a generous opening in the base to accommodate centred and slightly offset USB connections.
I might revise the design to cater for other phablet / large phone connection configurations and also allow better airflow to the rear-position microphone of the Nexus 6. Let me know if you want something specific, and I'll see what I can do.
If you are printing this for a Nexus 6, you could print this at 95% for a firmer fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!